1200 utilizes a triple band-stack VFO selection technique, that permits you to store up to three favorite frequencies and modes onto each band's VFO register. For example, you may store one frequency each on 14 MHz CW, RTTY, and USB, then recall these VFOs by successive, momentary presses of the [14] MHz band button. Each Amateur band key may similarly have up to three frequency/mode settings applied. Note that only the VFO-A system has the band stacks.

A typical setup, for the 14 MHZ band, might be arranged like this: Program 14.025, CW Mode, then press the [14] Mhz band button; Program 14.080, RTTY Mode, then press the [14] Mhz band button; Program 14.195, SSB Mode, then press the [14] Mhz band button. With this configuration, successive momentary presses of the [14] MHz band button will allow you to step sequencially through these three VFOs.

---

End of "Band Stack Operation"

---

C. S. (CUSTON SWITCH)

---

The front panel [C.S.] button may be programmed to directly access an often-used Menu Mode selection.

C.S. Setup: Press the [MENU] button to engage the Menu mode; the Menu list will appear on the display. Rotate the [VFO-B/CLAR] knob (or press the up/down button) to select the Menu item to want to access with the front panel [C.S.] button. Press the [C.S.] button to lock in your selection. Press the [MENU] button to save the new configureation and exit to normal operation. Menu Selection Recall via C.S. Button: Press the[C.S.] button. The programmed Menu item will appear on the display. Press the [MENU] button to exit to normal operation.

End of "C.S. (Custon Switch)"