|
(3) Configuration Indicator
TUNER
This indicator appears when the internal Automatic Antenna Tuner is activated.
VOX
This indicator appears when the automatic voice-activated transmitter switches in the SSB, AM, and FM modes.
PROC
This indicator appears whenever the DSP Speech Porcessor is activated.
MIC EQ
This indicator appears whenever the Three-Band Parametric Microphone Equalizer is activated via the Menu.
NAR
This indicator appears whenever the receiver's narrow IF DSP filter is engaged.
REC
This indicator appears while the optional Voice Memory Unit is recording your voice message, or the Contest Keyer is recording you CW keying.
PLAY
This indicator appears while the optional Voice Memory Unit is playing back the recorded your voice message, or the recorded CW keying.
[+]/[-]
During FM repeater operation, a negative frequency shift will be indicated by "[-]" while a postive frequency shift will be indicated by "[+]".
DNR
This indicator appears whenevr the Digital Noise Redurction feature is activated.
DNF
This indicator appears whenevr the Digital Notch Filter is activated.
(4) VFO-B Frequency Display
Shows the sub band (VFO-B) frequency during Split operation.
ADVICE:
|
(5) Tuning Offset Indicator
This indicates the relative offset of the CW-TUNE, u-TUNE, Clarifier, etd.
(6) S/PO Meter
On reception, this indicates the received signal strength from S-0 to S-9+60 dB.
On transmission, this indicates the RF Power Output, from 0 to 150 Watts.
ADVICE:
(7) DSP Display
This indicator is used for viewing the status of the DSP (CONTOUR, NOTCH, WIDTH and SHIFT).
(8) Key Function Display
ANT (1,2):
Indicates which antenna is selected by the front panel [ANT] button.
IPO (AMP1, AMP2, IPO):
Indicates which front end RF amplifier is selected by the front panel [IPO] button.
ATT (OFF, -6 dB, -12 dB, -18 dB):
Indicates the attenuation level, selected by the front panel [ATT] button.
R.FLT (3 kHz, 6 kHz, 15 kHz):
Indicates the receiver IF Roofing Filter that is selected by the front panel [R.FLT] button.
NB (OFF, ON, ON [NBW]):
Indicates the receiver's "short-duration" Noise Blanker setting, which is selected by the front panel [NB] button.
AGC (SLOW, FAST, MID):
Indicates the AGC decay time setting, which is selected by the front panel [AGC] switch.
|